Bedienungsanleitung Black & Decker CD12C

Black & Decker CD12C

Sprache(n):
Multi

Dateigröße:
398,70KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 2

Hersteller:
Black & Decker 

  • Bohrgeraet Black & Decker CD12C


  • Vorschau Black & Decker CD12C Handbuch:
    4 ENGLISH ◆ When disposing of batteries, follow the instructions given in the section “Protecting the environment”. ◆ Under extreme conditions, battery leakage may occur. When you notice liquid on the battery, proceed as follows: - Carefully wipe the liquid off using a cloth. Avoid skin contact. - In case of skin or eye contact, follow the instructions below. Warning! The battery fluid, a 25-30% solution of potassium hydroxide, can be harmful. In case of skin contact, immediately rinse with water. Neutralise with a mild acid such as lemon juice or vinegar. In case of eye contact, rinse abundantly with clean water for at least 10 minutes. Consult a physician. Fire hazard! Avoid short-circuiting the contacts of a detached battery (e.g. when storing the battery in a toolbox). Do not incinerate the battery. Do not attempt to charge damaged batteries. Chargers ◆ Use your Black & Decker charger only to charge batteries of the type supplied with your tool. Other batteries could burst, causing personal injury and damage. ◆ Never attempt to charge non-rechargeable batteries. ◆ Have defective cords replaced immediately. ◆ Do not expose to water. ◆ Do not open the charger. ◆ Do not probe the charger. The charger is intended for indoor use only. Electrical safety Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate. Never attempt to replace the charger unit with a regular mains plug. Features This tool includes some or all of the following features. 1. Variable speed switch or two-speed on/off switch 2. Forward/reverse slider 3. Mode selector / torque adjustment collar 4. Chuck 5. Battery 6. Battery release button Fig. D & E 7. Charger 8. Charging base 9. Charger connector 10. Charger plug Assembly Fitting and removing the battery (fig. A) ◆ To fit the battery (5), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. ◆ To remove the battery, push the two release buttons (6) simultaneously while at the same time pulling the battery out of the receptacle. Fitting and removing a drill bit or screwdriver bit (fig. B) Warning! First remove the battery from the tool. This tool is fitted with a keyless chuck to allow for an easy exchange of bits. ◆ Lock the tool by setting the forward/reverse slider (2) to the centre position. ◆ Open the chuck by turning the front part (11) with one hand while holding the rear part (12) with the other (fig. B). ◆ Insert the bit shank (13) into the chuck. ◆ Firmly tighten the chuck by t .....
    Klicken Sie jetzt für den Download