Bedienungsanleitung Black & Decker GK430

Black & Decker GK430



DSL 16k: 1s

Downloads bisher: 8

Black & Decker 

  • Handgeraet Black & Decker GK430

  • Vorschau Black & Decker GK430 Handbuch:
    4 Existing cable systems (UK only) If you already own an outdoor cable system, we recommend that you replace the existing “female” cable connector with the new ‘female’ connector (see below) which is supplied loose in the carton. (Please read the section entitled ”fitting the ‘female’ connector”.) old ‘female’ connector new ‘female’ connector Should you wish to convert more than one cable system, the new female connector is available as an accessory from most major DIY retail outlets and from Black & Decker Service Stations (cat. no. A6624S). Existing powered garden tools (UK only) To connect existing Black & Decker garden power tools to the new system you will require an adaptor (see below). This is available as an accessory from most major DIY retail outlets (cat. no. A6623S). Fitting your own extension cable (UK only) • When fitting your own extension cable fit a 13 amp plug (see “fitting the mains plug”) to one end of the cable and a ‘female’ connector (supplied loose in the carton) to the other end (see below). For wiring instructions see the following sections. • A ‘male’ connector is already attached to the electrical supply cable on your machine and is designed to be non-rewireable. This should not be removed (see below). Should the cable and plug become damaged or need replacing, please return the machine to your Black & Decker Service Station. ‘female’ connector ‘male’ connector • WARNING! Never wire an extension cable with anything other than the ‘female’ connector supplied and a 13 amp BS1363A approved plug with the recommended fuse. Never wire a ‘male’ connector to your extension cable and never wire an extension cable with a plug of any kind at each end of the cable. This is extremely dangerous and results in the pins being live which may cause a fatal electric shock. • Note: The recommended fuse for use with this machine is 13 amps. Fitting the ‘female’ connector (UK only) To remove the cover, unscrew the fixing screw until it is free of the nut which is located in the hexagonal recess on the underside of the connector. Take care not to lose the nut if it falls out. There is no need to completely remove the fixing screw as it is intended to remain captive in the cover. The cover can now be removed by applying pressure as shown below. apply pressure here The extension cable contains two wires which are colour coded for easy recognition; brown is for ‘Live’ (L) and blue is for ‘Neutral’ (N). The female connector is marked ‘L’ for live and ‘N’ for neutral. These markings are located inside the body near the termi .....
    Klicken Sie jetzt für den Download