Bedienungsanleitung D Link DMC 300 SC

D Link DMC 300 SC

Sprache(n):
Englisch


Dateigröße:
110,42KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 5

Hersteller:
D Link 

  • Verbindungsgeraet D Link DMC 300 SC


  • Vorschau D Link DMC 300 SC Handbuch:
    4 INSTALLATION This chapter gives step-by-step installation instructions for the Converter. Selecting a Site for the Equipment As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements: 1. The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius). 2. The relative humidity should be less than 90 percent, non-condensing. 3. Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3, Level 2 (3V/M) field strength. 4. Make sure that the equipment receives adequate ventilation. Do not block the ventilation holes on each side of the switch or the fan exhaust port on the side or rear of the equipment. 5. The power outlet should be within 1.8 meters of the switch. 5 Connecting to Power 1. This Converter is a plug-and-play device. 2. Connect the supplied AC to DC power adaptor with a power voltage of 7.5Vdc/1.5Amp to the receptacle on the rear panel of the converter, and then attach the plug into a standard AC outlet with a voltage range from 100 to 260 Vac. Sliding Switch There is a sliding switch for duplex mode setting for fiber port. Refer to the table below for more details. Half Duplex Full Duplex (default) 6 Connecting to Power 3. This Converter is a plug-and-play device. 4. Connect the supplied AC to DC power adaptor with a power voltage of 7.5Vdc/1.5Amp to the DC-Jack on the converter, and then attach the plug into a standard AC outlet. Installing in a Chassis The Converter can be fit into any of the expansion slots on a special designed chassis.  First, install the converter onto a carrier supplied with the chassis: Step 1- Unscrew and pull out the media converter board. Step 2- Plug in the media board to any of the vacant slot. Step 3- Fit the converter onto the carrier and use the screw to secure it. .....
    Klicken Sie jetzt für den Download