Bedienungsanleitung D Link DMC 700 SC

D Link DMC 700 SC

Sprache(n):
Englisch


Dateigröße:
117,41KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 26

Hersteller:
D Link 

  • Uebertragungsgeraet D Link DMC 700 SC


  • Vorschau D Link DMC 700 SC Handbuch:
    2 TABLE OF CONTENTS TABLE OF CONTENTS ..........2 INTRODUCTION.................3 ABOUT MEDIA CONVERTER .........................3 PRODUCT FEATURES ......4 INSTALLATION ..................5 SELECTING A SITE FOR THE EQUIPMENT.....5 CONNECTING TO POWER .............................5 INSTALLING IN A CHASSIS ............................5 MONITORING THE CONVERTER THROUGH MANAGEMENT MODULE ...............................6 LED INDICATOR ...........................................7 LINK PASS THROUGH FUNCTION .................7 SWITCH.........................................................9 SPECIFICATIONS ............ 10 3 INTRODUCTION Thank you for choosing the 1000Base Gigabit Ethernet Media Converter, The Converter introduced here provides one channel media conversion between 1000BASE-TX and 1000BASE-FX. About Media Converter Media Converter is a network technology specified by IEEE 802.3ab and IEEE 802.3z 1000BASE-TX/FX standards. 4 PRODUCT FEATURES  Hot-swappable when used with a chassis  One-channel media conversion between 1000BASE-TX and 1000BASE-FX  Fiber media allows: multi-mode fiber and single-mode fiber using SC connector  Link Pass Through function  Auto negotiation of duplex mode on TX port  Auto MDI/MDI-X for TX port  Full wire-speed forwarding rate  Front panel status LEDs  Used as a stand-alone device or with a chassis  Hot-swappable when used with a chassis 5 INSTALLATION This chapter gives step-by-step installation instructions for the Converter. Selecting a Site for the Equipment As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements: 1. The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius). 2. The relative humidity should be less than 90 percent, non-condensing. 3. Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3, Level 2 (3V/M) field strength. 4. Make sure that the equipment receives adequate ventilation. Do not block the ventilation holes on each side of the switch or the fan exhaust port on the side or rear of the equipment. 5. The power outlet should be within 1.8 meters of the switch. Connecting to Power 1. This Converter is a plug-and-play device. 2. Connect the supplied AC to DC power adaptor with a power voltage of 7.5Vdc/1.5Amp to the DC-Jack on the converter, and then attach the plug into a standard AC outlet. Installing in a Chassis The Converter can be fit into any of the expansion slots on a sp .....
    Klicken Sie jetzt für den Download