Bedienungsanleitung E Flite EFLA 1025

E Flite EFLA 1025

Sprache(n):
Englisch


Dateigröße:
127,27KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 2

Hersteller:
E Flite 

  • Kontrollgeraet E Flite EFLA 1025


  • Vorschau E Flite EFLA 1025 Handbuch:
    (continued) Entering the Programming Mode 1. With the battery disconnected from the controller, and the transmitter turned on, first move the throttle stick to full throttle (>1.7ms) position. Leave it in this position and then connect the battery to the controller. 2. Wait for 5 seconds, and the ESC will give two sets of fast ringing tones to indicate you have successfully entered the programming mode. 3. Once you hear these tones, move the stick to center (between 1.4 and 1.6ms), and the controller will beep 1 time, this indicates menu item 1. 4. The controller will now wait 5 seconds for you to make your selection; your programming options are either full throttle (>1.7ms), or idle (<1.3ms). 5. When you have made a valid selection, the control will beep once with a lower tone, and you can move the stick back to center for the next menu item (2 beeps, 3 beeps and so on). If you do not make a selection within 5 seconds, the controller will move to the next menu item. 6. Please note that if you do not need to program every menu item, you can simply exit the programming mode after you have made the required selections. You can do this by moving the throttle stick straight to idle after making your selection, or leaving it in the idle position if you made a no selection (for approximately 8 seconds) until you hear one set of 3 medium length rising tones that indicate the controller has armed the motor, or by simply unplugging the battery. Remember, when in the programming mode: Full Throttle = Stick Up Idle = Stick Down The default settings (from the package) for your E-flite 25-Amp Pro ESC are as follows: • 3S (9V) auto cut-off for Li-Po • Brake Off • 4 pole and greater timing (outrunner or 6-pole motors) • Throttle input range set to Auto Select mode (1.2ms-1.8ms) Programming Menu 1 – Voltage Cut-off Use this option to set the voltage at which the controller will shut down the motor to prevent damage to your battery, when it reaches the cut-off voltage. You will know your battery pack has reached auto cut-off when you hear the motor “pulse” repeatedly. 1. 3S Li-Po voltage cut-off – Full Throttle 2. 2S Li-Po or Ni-Cd/Ni-MH voltage cut-off – Idle 3. 70% Smart Cut soft cut-off (See below for Smart Cut information) NOTE: To access the 70% Smart Cut option, leave the stick at full throttle for 7 seconds while in menu item 1, until 7 beeps are heard, then continue through the program normally. This option will activate the soft cut-off at 70% of startup voltage. For example, if your pack measures 10.0 volts at startup, then the soft cut will occur at 7.0 volts. The Smart Cut option will chec .....
    Klicken Sie jetzt für den Download