Bedienungsanleitung Gemini CD 340

Gemini CD 340

Sprache(n):
Multi


Dateigröße:
158,05KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 0

Hersteller:
Gemini 

Music Player Gemini CD 340


Vorschau Gemini CD 340 Handbuch:
Page2 6 1 3 4 2 5 16 15 10 12 13 11 14 18 17 19 20 7 7 8 9 Page3 22 23 24 25 21 Page4 INTRODUCTION Congratulations on purchasing a Gemini CD-340 Dual CD Player. This state of the art professional CD player is backed by a three year warranty, excluding lasers. One year warranty on CD lasers. Prior to use, we suggest that you carefully read all the instructions. CAUTIONS Do not use this CD Player at temperatures below 41°F/5°C or higher than 95°F/35°C. Place the unit in a clean and dry location. Do not place the unit in an unstable location. When disconnecting the power cord from an AC outlet, always grasp it by the plug. Never pull the power cord. To prevent electric shock, do not remove the cover or the bottom screws. There are no user serviceable parts inside. Please refer servicing to a qualified technician. Do not use chemical solvents to clean the unit. Keep the laser pickup clean by keeping the drawer closed. Keep this manual in a safe place for future reference. SAFETY CERTIFICATIONS Laser Diode Properties Material: Ga - Al - As Wavelength: 755 - 815 nm (25° C) Laser Output: Continuous Wave, max. 0.5mW IMPORTANT NOTE Since the CD-340 is a dual CD player, most of the functions and controls are duplicated on both sides of the CD player. To eliminate confusion and to make the drawings easier to understand, we will only number the right side functions and controls. The only controls that are not duplicated are the ROBO START (1), POWER (20) switch and the VOLTAGE SELECTOR SLIDE (22) switch. LINE VOLTAGE SELECTION Model CD-340 is a dual voltage unit. It will operate at 115 or 230 volts. To set the proper voltage follow these steps: 1. Place the head of a screw driver in the center of the VOLTAGE SELEC- TOR SLIDE (22) switch found on the rear panel. 2. Slide the switch left for 115 volts or push the switch right for 230 volts. 3. Do not force or twist the switch. Excessive force may cause damage. If the switch does not move smoothly, contact a qualified technician. CONNECTIONS 1. Using the included cable, plug one end into the REMOTE JACK (21) and the other end into the PLAYER JACK (23). 2. Plug one end of a set of RCA connectors into each of the LINE OUTPUT (25) jacks. 3. Plug the other end of the RCA connectors into any available line level input jacks on your mixer. If you are playing the CD-340 through a receiver, you can plug the RCA connectors into the CD or AUX input jacks on your receiver. If there are no CD or AUX inputs, use any line level (not phono) inputs. FUNCTION DESCRIPTIONS ANTI-SHOCK BUFFER MEMORY: With 20 SECONDS OF ANTI-SHOCK BUFFER MEMORY, each side of the CD player stores 10 .....
Klicken Sie jetzt für den Download