Bedienungsanleitung Intermec ScanPlus 1802

Intermec ScanPlus 1802

Sprache(n):
Englisch


Dateigröße:
124,41KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 2

Hersteller:
Intermec 

  • Scansystem Intermec ScanPlus 1802


  • Vorschau Intermec ScanPlus 1802 Handbuch:
    0 cm - 33 cm (0" - 13") 0 25 m (80 ft) 2 3 PDF417 codes One-dimensional codes Operation The ScanPlus 1802 Vista Cordless System consists of a base station (MicroBar 9735) and at least one scanner (ScanPlus 1802 VT PDF). "beep" 7.5 cm (3") PDF417 ideal reading distance Reading distance Range "beep beep beep beep beep beep" "beep" 4 5 ➊ ➋ ➌ WARNING: Fire, explosion and severe burn hazard. Do not crush, disassemble, heat above 212° F (100° C) or incinerate Battery Pack (P/N 3-360029-03). Low battery Regulatory statements Intermec hereby declares that the ScanPlus 1802 Vista Cordless System has been tested and found com- pliant with the below listed standards as required by the R&TTE Directive 99/05/EC: ETS 301 489, EN 300 220-1, EN 60950 and EN 60825-1. This device is TÜV GS licensed (EN 60950 and EN 60825-1). The original Declaration of Conformity is available on demand. The ScanPlus 1802Vista Cordless System is certified for use in all countries belonging to the European Union. USA & Canada: This device complies with Part 15 of the FCC rules and RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuanttopart15oftheFCC rules. These limits are designed to provide a reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna, increase the separation between the equipment and the receiver, connect the equipment into an outlet on a circuit different from that to which the receiver is connected or consult the dealer or an experienced radio/TV technician for help. In order to maintain compliance with the FCC Rules, the I/O cables that interconnect between the device and any peripheral must be as specified by Intermec. Caution: Changes or modifications not expressly approved by Intermec could void the user's authority to operate this equipment. This Class B digital apparatus meets all requirements of the Canadian Interference-Cau .....
    Klicken Sie jetzt für den Download