Bedienungsanleitung Jablotron JA 80Y

Jablotron JA 80Y

Sprache(n):
Multi

Dateigröße:
89,64KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 1

Hersteller:
Jablotron 

  • Waehlgeraet und Kommunikationsmodul Jablotron JA 80Y


  • Vorschau Jablotron JA 80Y Handbuch:
    JA-80Y user manual MFJ55800 4 Notes: • As a factory default, setting (arming) by a SET instruction is confirmed by the system via an SMS reply. • When the current system status does not allow system operation (e.g. when in programming mode), you will be notified about the situation via an SMS reply. • In a split system, an xxxx_SET instruction will only have an effect on the section to which the code xxxx belongs. 3. Unsetting (disarming) by SMS xxxx_UNSET The UNSET instruction allows you to unset (disarm) the system, fully or partially. If the system is already unset, it will not change its status. Send an SMS message containing: xxxx_UNSET where: xxxx is a valid access code (user or master) _ is a space character Example: Sending 4321 UNSET will unset the system the same way as if the code 4321 had been entered on the system keypad. Notes: • As a factory default, unsetting (disarming) by an UNSET instruction is confirmed by the system via an SMS reply. • When the current system status does not allow system operation (e.g. when in programming mode), you will be notified about the situation via an SMS reply. • In a split system, an xxxx_UNSET instruction will only have an effect on the section to which the code xxxx belongs. 4. Status interrogation xxxx_STATUS The STATUS instruction allows you to get information about the current system status. The communicator will reply with an SMS reporting the current set/unset status, GSM signal strength, GPRS connection status and transmission success/failure status for each ARC involved. Send an SMS message containing: xxxx_STATUS where: xxxx is a valid access code (user or master) _ is a space character Example: If the system is set, an SMS instruction 4321 STATUS will by replied to by the system via an SMS message which might look like the following: Report from your alarm: System status: Set, GSM:3/4, GPRS OK, MS1 OK, MS2 OK JA-80Y user manual MFJ55800 5 where GSM:3/4 means the GSM signal strength is at least 75 percent, GPRS OK means communication via GPRS has been successfully established and MS1 OK, MS2 OK means that all relevant data has been transmitted to monitoring stations MS1 and MS2. 5. Last event interrogation xxxx_MEMORY On receiving a MEMORY instruction, the communicator will reply by reporting the last event recorded in the control panel memory. Send an SMS message containing: xxxx_MEMORY where: xxxx is a valid access code (user or master) _ is a space character Example: If an alarm has been triggered, the communicator will reply to the SMS instruction 4321 MEMORY by reporting: Report from your alarm: Last event: Alarm end Cont .....
    Klicken Sie jetzt für den Download