Bedienungsanleitung JBL SCS135

JBL SCS135

Sprache(n):
Englisch


Dateigröße:
138,83KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 43

Hersteller:
JBL 

  • Soundsystem JBL SCS135


  • Vorschau JBL SCS135 Handbuch:
    6 7 Separate and strip the ends of the speaker wire as shown. Speakers and electronics terminals have corresponding (+) and (–) terminals. Most manu- facturers of speakers and electronics, including JBL, use red to denote the (+) terminal and black for the (–) terminal. The (+) lead of the speaker wire is noted with a stripe. It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (–) on the speaker to (–) on the amplifier. Wiring “out of phase” results in thin sound, weak bass and a poor stereo image. With the advent of multichannel surround- sound systems, connecting all of the speakers in your system with the correct polarity remains equally important in order to preserve the proper ambience and directionality of the program material. S P E A K E R C O N N E C T I O N S Connection Tips Dolby* Pro Logic* (Non-Digital) – Speaker Level Use this installation method for Dolby Pro Logic appli- cations (not Dolby Digital, DTS® or other digital processing), where the receiver/processor does not have a subwoofer output, or a volume-controlled preamp (line-) level output: Connect your receiver or amplifier’s front left and right speaker terminals to the left and right terminals on the subwoofer that are marked “High Level In.” Connect the left and right terminals on the subwoofer that are marked “High Level Out” to the cor- responding terminals on the back of your front left and right speakers. Connect your receiver or amplifier’s center, left and right surround-speaker terminals to the corre- sponding terminals on the back of your center, left and right surround speakers. Right Front Right Surround Left Front Left Surround Center + – + – + – + – + – + – + – Left Front Center + – Left Surround Right Front + – Right Surround + – Subwoofer Receiver HIGH LEVEL + – – + L R OUT IN Dolby Pro Logic (Non-Digital) – Line Level 8 9 Use this installation method for Dolby Pro Logic appli- cations (not Dolby Digital, DTS or other digital processing), where the receiver/processor is equipped with a subwoofer output, or a volume-controlled preamp (line-) level output: Use RCA-type patch cords to connect the line-level subwoofer outputs on your receiver or amplifier to the line-level inputs on the subwoofer. IMPORTANT: Do not use the LFE input on the subwoofer with Dolby Pro Logic processors. Note: If your receiver or amplifier only has one subwoofer output jack, then you will need to use a Y-connector (not included). Plug the male end of the Y- connector into your receiver or amplifier’s subwoofer output jack, and connect eac .....
    Klicken Sie jetzt für den Download