Bedienungsanleitung La Crosse Technology WS 9133T

La Crosse Technology WS 9133T

Sprache(n):
Englisch


Dateigröße:
177,51KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 2

Hersteller:
La Crosse Technology 

  • Messgeraet La Crosse Technology WS 9133T


  • Vorschau La Crosse Technology WS 9133T Handbuch:
    5 light up briefly. Following the time as 12:00 and the weather icon will be displayed. If these are not displayed after 60 seconds, remove the batteries and wait for at least 10 seconds before reinserting them. 3. After inserting the batteries, the Weather station will start receiving data from the transmitter. The outdoor temperature and the signal reception icon should then be displayed on the Weather station. If this does not happen after 3 minutes, the batteries will need to be removed from both units and reset from step 1. 4. In order to ensure sufficient 915 MHz transmission however, this should under good conditions be a distance no more than 100 meters (330 feet) between the final position of the Weather Station and the transmitter (see notes on “Mounting” and “915 MHz Reception”). HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION The Weather Station uses 3 x AA, IEC LR6, 1.5V batteries. When batteries will need to be replaced, the low battery icon will appear on the LCD. To install and replace the batteries, please follow the steps below: 1. Lift up the battery compartment cover. 2. Insert batteries observing the correct polarity (see marking). 3. Replace compartment cover. 6 HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER The Temperature Transmitter uses 2 x AA, IEC LR6, 1.5V battery. To install and replace the batteries, please follow the steps below: 1. Remove the battery compartment cover at the back of the transmitter. 2. Insert the batteries, observing the correct polarity (see marking). 3. Replace the battery compartment cover on the unit. Note: In the event of changing batteries in any of the units, all units need to be reset by following the setting up procedures. This is because a security code is assigned by the transmitter at start-up and this code must be received and stored by the Weather station in the first 3 minutes of power being supplied to it. BATTERY CHANGE: It is recommended to replace the batteries in all units regularly to ensure optimum accuracy of these units (Battery life See Specifications below). Please participate in the preservation of the environment. Return used batteries to an authorized depot. FUNCTION KEYS: Weather station: The weather station has four easy to use function keys. 7 SET key  Press the key to enter manual setting modes: time, 12/24 hour time display, and temperature unit (ºC/ºF) setting  Stop the alarm + key  To make adjustment for various settings  Stop the alarm ALARM key  Enter the alarm setting mode  Switch the alarm ON/ OFF  Stop the alarm MIN/MAX RESET key  Press and hold .....
    Klicken Sie jetzt für den Download