Bedienungsanleitung Manley 35 PM4 Monoblock Amplifier

Manley 35 PM4 Monoblock Amplifier

Sprache(n):
Englisch


Dateigröße:
28,11KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 2

Hersteller:
Manley 

  • Verstaerkersystem Manley 35 PM4 Monoblock Amplifier


  • Vorschau Manley 35 PM4 Monoblock Amplifier Handbuch:
    MAINS CONNECTIONS Your amplifier has been factory set to the correct mains voltage for your country. The voltage setting is marked on the serial badge, located on the rear panel. Check that this complies with your local supply. Export units for certain markets have a moulded mains plug fitted to comply with local requirements. If your unit does not have a plug fitted the colored wires should be connected to the appropriate plug terminals in accordance with the following code. GREEN/YELLOW EARTH terminal BLUE NEUTRAL terminal BROWN LIVE terminal As the colors of the wires in the mains lead may not correspond with the colored marking identifying the terminals in your plug proceed as follows; The wire which is colored GREEN/YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or colored GREEN or GREEN and YELLOW. The wire which is colored BLUE must be connected to the terminal in the plug which is marked by the letter N or colored BLACK. The wire which is colored BROWN must be connected to the terminal in the plug which is marked by the letter L or colored RED. DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER CONNEC- TIONS HAVE BEEN MADE. CONNECTING YOUR AMPLIFIER Setting up your amplifier is rather easy. 1. Connect all source components (turntable, CD, Tuner, Tape DAT, etc.) to your preamplifier. 2. Connect the interconnects from the output of the preamplifier or switching center to the RCA input on the top rear of the amplifier. 3. Connect the hot or "+" speaker cable to the red binding post and the common or "-" speaker cable to the black binding post (See diagram 2). Ensure that the other end of the cable is connected correctly to the speaker. Tighten the binding posts by hand. If you use a nut-driver (3/8") do not over-tighten the posts or you may breaak the connection inside the amplifier. 4. Insure that the "mains" switch on the front panel is in the "off" or "0" position. 5. Turn on Preamplifier and any source components you plan to use. 6. Plug amplifier into wall outlet. 7. Turn on the amplifier and allow it to 'warm up' a minute or so before playing any audio signal. 8. Turn up the volume and enjoy. BIAS PROCEDURES The Manley 50 Watt Amplfier is a fixed bias system that requires very little attention. If you wish to adjust or check the bias, complete the following steps. For this procedure you will need a multimeter to read millivolts (less than 2 volt range) and a small flat screwdriver. 1. Looking at the front section of the top plate of the amplifier, you can see 4 red tip jacks and 1 black tip jack. To measure the curre .....
    Klicken Sie jetzt für den Download