Bedienungsanleitung SpeakerCraft CSS6

SpeakerCraft CSS6

Sprache(n):
Englisch


Dateigröße:
192,45KB

Downloadzeit:
DSL 16k: 1s

Downloads bisher: 1

Hersteller:
SpeakerCraft 

  • Sound System SpeakerCraft CSS6


  • Vorschau SpeakerCraft CSS6 Handbuch:
    Page 2 CSS6 Series Owner’s Manual CSS6 Series Owner’s Manual Page 3 4. Cutting the hole. CAUTION:This is the most important part of the entire installation. If you are uncertain whether any obstructions exist behind the desired mounting area, you should start by cutting a small hole in the center of your penciled mounting hole with a drywall saw, cutting at a 45º angle towards the inside of the hole. (See Diagram 2) Cutting the small hole at this angle will make drywall repair much easier, using the piece cut out. Once you have determined that there aren’t any obstructions in your desired mounting location, start cutting the finished hole at a 90º angle to the ceiling surface. 5. Add insulation. If the area in the ceiling is not already insulated, add an adequate amount insulation material to loosely cover the back of the speaker. If the insulation material used is faced with foil or paper, position the foil or paper away from the speaker. SPEAKER ADJUSTMENTS Your CSS6 Series speakers come from the factory with the tweeter facing straight out from the baffle. This will result in the overall smoothest response. However, depending on your particular primary area, room acoustics, ceiling height, or personal preference, you may find the sound more pleasing by pointing the tweeters in a particular direction. If additional treble is desired in the primary listening area, point the tweeter towards that area; and if less treble is required, point the tweeter away. Push gently at the edge of the tweeter to point it in the desired direction. (See Diagram 3) CAUTION: Avoid touching tweeter dome as damage WILL occur on metal dome tweeters (CSS6 ONE & THREE). Tweeter Adjustment (CSS6 THREE): The switch labeled TREBLE allows for 6dB of tweeter adjustment. Your speakers were shipped with the treble switch in the neutral position, providing the most linear frequency response. If you desire more treble, roll the switch to the “+” position, and the tweeter will play 3dB higher. If you want less treble, roll the switch to the “–” position and the tweeter will play 3dB lower. To return to the neutral setting, slide the switch to the middle position. (See Diagram 4) Woofer Adjustment (CSS6 THREE): The switch labeled BASS allows for 6dB of bass adjustment. Your speakers were shipped with the bass set to neutral, resulting in 6Ω of impedance. This setting provides the flattest bass frequency response. If you desire more bass, roll the switch towards “+” and the bass will play 3dB higher and lower the impedance to 4Ω. If you want less bass, roll the switch towards “–” and the bass will play 3dB lo .....
    Klicken Sie jetzt für den Download